Hi,

Does anyone have any documentation/manual showing how to read the data on Traffic Signal Timing Sheets provided by City/DOT?

I need to figure out how to read this info properly so I can code them into Synchro 7 for buiding existing conditions. I believe the ones that I have is for signal controller 170.

Would greatly appreciated all your help and effort for any insight/documentation.

Thanks,

mtran

In my experience, EVERYONE has a different method for writing down or tabulating the parameters of the actual controllers. Cities, Counties, State, etc. I had to spent about 2 hours sitting down with our Signal Operations folks going over the parameters in their spreadsheets one by one and figuring what paramter in Synchro would meet that the closest.
You're going to have to take the time. Its worth it, as after the first time, you shouldn't have to worry about it again.

Eric,

Thank you for sharing your valuable experience.

Thanks,

Mtran